Tip of wire is protruded from the base elastomer for 20um and Ni/Au plating was done to improve contact. Initial contact start at very low compressed stage thus reduce mechanical strain on device under test. Comparing to MT-T type, MT-P type has much improved durability (Depending on device type).

MT-P type:

Outline Dimensions:

Dimensions and Tolerances:

0.25t 0.15t  Thickness (mm) 0.25 +0.05 -0 0.15 +0.05 -0  Pitch (mm) Pi: 0.10 ± 0.03, Ps: 0.10 ± 0.05  Length (mm) Max : 15 ± 1.0 Min : 5 ± 0.5 Max : 10 ± 1.0 Min : 5 ± 0.5  Width (mm) Max : 50 ± 1.0 Min : 5 ± 0.5 Max : 10 ± 1.0 Min : 5 ± 0.5  Offset (mm) 0.125 0.075

Characteristics: