SS-type

SS-type Inter-Connector consists of alternate layers of conductive and insulating silicone rubber and of rubber insulators with less stiffness, which are fitted on both sides. This type is suitable for small- or middle-sized displays, cell phones and other consumer electronics.
While SS type has translucent supportive solid rubber on the both sides, SG type has pink sponge rubber.

Compression Curves:

Outline Dimensions:

  • SS-type of Inter-Connector
  • SS-type of Inter-Connector
Inquiry

Application

  • DM-type Application - Car LCD

Dimensions and Tolerances:

Item Unit SS type
Pitch P mm
0.10±0.04
0.18±0.05
0.25±0.05
Length L mm
2.0~20.0±0.15
90.1~150.0±0.6
200.1~275.0±1.0
20.1~90.0±0.65%
150.1~200.0±0.8
Height (1) H mm
1.0~5.0±0.1
5.1~20.0+0.15/-0.1
Width (standard) W mm
1.0~2.3±0.1
2.4~5.0±0.15
Width of conductive layer Z mm
0.3±0.05
0.6±0.05
*SS-N type, which has non-sticky sides is available on request.
(1)H≧W/2

Basic Properties:

Item Component Unit SS type
Specific gravity Insulator
Conductor
Edge insulation part
1.15
1.25
1.10
Shore hardness A Insulator
Conductor
Edge insulation part
ISO7619
(type A)
65~73
63~67
20~25
Compression set * % 12~18
Volume resistivity Insulator
Conductor
Edge insulation part
Ω/cm 1 x 1014
3~6
8 x 1013
Dielectric breakdown voltage Insulator
Edge insulation part
kV/mm 23~27
23~27
Insulation resistance (500V DC) * 1 x 103
Operating temperature range ºC -25~85
*The test is carried out with Shin-Etsu’s own method.
Note:
Every item or numerical value indicated herein is measured by Shin-Etsu and out of guarantee.
The quality of the connector, which has been already assembled, is out of guarantee.
Please make sure to see about the purpose/conditions of use and practice your own test. Industrial ownership like patent doesn’t guarantee the usage of the connector.
2020-09-24T09:32:45-07:00
Go to Top