SS-type

SS-type Inter-Connector consists of alternate layers of conductive and insulating silicone rubber and of rubber insulators with less stiffness, which are fitted on both sides. This type is suitable for small- or middle-sized displays, cell phones and other consumer electronics.
While SS type has translucent supportive solid rubber on the both sides, SG type has pink sponge rubber.

Compression Curves:

Outline Dimensions:

Inquiry

Application

Dimensions and Tolerances:

Item		Unit	SS type
Pitch	P	mm	0.10±0.04 0.18±0.05 0.25±0.05
Length	L	mm	2.0~20.0±0.15 90.1~150.0±0.6 200.1~275.0±1.0 20.1~90.0±0.65% 150.1~200.0±0.8
Height (1)	H	mm	1.0~5.0±0.1 5.1~20.0+0.15/-0.1
Width (standard)	W	mm	1.0~2.3±0.1 2.4~5.0±0.15
Width of conductive layer	Z	mm	0.3±0.05 0.6±0.05

*SS-N type, which has non-sticky sides is available on request.
(1)H≧W/2

Basic Properties:

Item	Component	Unit	SS type
Specific gravity	Insulator Conductor Edge insulation part		1.15 1.25 1.10
Shore hardness A	Insulator Conductor Edge insulation part	ISO7619 (type A)	65~73 63~67 20~25
Compression set	*	%	12~18
Volume resistivity	Insulator Conductor Edge insulation part	Ω/cm	1 x 10¹⁴ 3~6 8 x 10¹³
Dielectric breakdown voltage	Insulator Edge insulation part	kV/mm	23~27 23~27
Insulation resistance (500V DC)	*	MΩ	1 x 10³≦
Operating temperature range		ºC	-25~85

*The test is carried out with Shin-Etsu’s own method.

Note:
Every item or numerical value indicated herein is measured by Shin-Etsu and out of guarantee.
The quality of the connector, which has been already assembled, is out of guarantee.
Please make sure to see about the purpose/conditions of use and practice your own test. Industrial ownership like patent doesn’t guarantee the usage of the connector.